Hi there,
We have recently bought a used 1000mw rgb laser from ebay, its a meirlight chinese unit and im quite impressed with it so far. It came with 30K scanners that worked well but we have now installed some 40K scanners from NRG lasers in manchester. With a bit of fiddleing we have aligned the diodes quite well, but the scanners need setting up properly and im not sure on a few things.
1, When the scanners are spec'ed as 40k at 20 degrees, is this +/- 20 degrees or +/- 10 degrees?
When i set the size in Quickshow to 50% x 50% (default) im getting 20 degrees (+/- 10 degrees) so when i set the size to 100% im getting 40 degrees from the laser (+/- 20 degrees)
Is this normal? Im about to have a go at tuning the scanners so i really need to know what size to set it to.
Also, is there any way to get quickshow to run faster than 30K? Or do i have to buy livepro or some other software to use scanning speeds faster than 30K?
Many thanks.
James