Hello all,
I received my new 1.3W Laser Projector last week and have been messing around with it and noticed one thing in particular that caught my attention.
On the Quadrature Test Pattern I have double lines on the top right side and the bottom left side; is this an alignment issue?
Also is this something to be concerned about or not? My colors look great and I have good white balance and was able to fine tune it pretty well in Quick Show 2.0.
My images appear to scan well also. However, I'm still new to all this and was wondering about the double lines in that one test pattern.
Sorry I don't have a picture right now but I left my camera at home. I will put up a picture when I get home later.
Any information or advice on this would be greatly appreciated.
My system specs are listed below:
300mW 640nm Analog 10k
200mW 532nm Analog 10k
800mW 447nm Analog 10k
40kpps scanners
Thanks in advance,
Mike