Coming soon

[edison]

Hello guys,

As some people know that i have worked the last year on getting my own modulees of red and blue. Now i,m getting closer and closer so just to show you guys the results her are some picturess of the red modules. I,m busy with getting my own driver so the first modules will be avialable with a flexmod and die4chill. The first module you see in the picture is now on its way to Rob Stanwax. The first modules are 90mmx70mm and 50mm in height. I have a smaller design that is coming soon. If everything goes well i should have bigger blues ready soon.

The reds are available in 637nm, and a mix of 637nm and 660. The beamspecs are 3.5x3.5 with 0.65mrd.

The models that are available are a single, dual, quad, 6 combiner and 8 combiner.
Higher powers from 1.4 watt 637 are available but only in a mix of 637nm and 660nm

Its just to show you guys what,s coming

I have 25 housings for building quads and hopefully the driver will be soon ready. In the mean time a commercial driver like the Flexmod.

stay tuned for more info

[andy_con]

Edison you didnt reply to my PM

[edison]

That,s right i was busy with glueing the mirrors on my quads to be. Pm is on you way.

[andy_con]

That,s right i was busy with glueing the mirrors on my quads to be. Pm is on you way.

ok

[DjMagnus]

Looks nice these little thingies!
Good work!

[edison]

Thanks Magnus!!!! It will be smaller in time but its good for now. Smaller is nice but not really nessesary stability is

[flecom]

so I didn't quite understand, you can make 637nm modules up to 1.4W?

[LaNeK779]

so I didn't quite understand, you can make 637nm modules up to 1.4W?

an 8-diode setup using 637nm diodes 8*0.17 = 1.36 if i get it correctly

[VJ AIWAZ]

Edison did you get my pm also ??

[taggalucci]

an 8-diode setup using 637nm diodes 8*0.17 = 1.36 if i get it correctly

I read these can be run up to 200mW so with losses from combining...