once knfe edged together and passing throught all the optics you only get 2.5watts out. diodes are set to 1watt each
once knfe edged together and passing throught all the optics you only get 2.5watts out. diodes are set to 1watt each
Eat Sleep Lase Repeat
So you're loosing 1,5W? (37%)
I don't mean to piss on your work, its very nice, but would't it have been better to make the base plate a little bigger so the block for the prisms and the FET would fit on there completely?
correct.
that is how the driver is suppose to be and design error on my part for the prism pairs. but hey its not the end of the world
Eat Sleep Lase Repeat
Nice build nonetheless![]()
When you stated the 4x1 watt diodes were combining to produce 2.5 watt output, I took another look at your photos of the module. The second knife edge mirror in the foreground and the PBS look pretty bright. In an attempt to produce a more compact stacked beam I've been surprised at the loss associated with what seems like minimal vignetting or spill over the top edge of the mirror. Having had larger losses than I liked with a couple of cube/wave plate combinations I've ordered a few alternatives to trial and will post the results.
did a bit of work today moutning things
anyone got any good methods of protecting wires from edges going through base plates?
![]()
Eat Sleep Lase Repeat
Looking good Sir! What are you planning on for red?
For wires around edges I would say get some rubber gromets or use a dremel to round the edges of the plate.
no red plans at the moment, but space left.
cant use a rubber gromet as the base plate is 10mm thick.
Eat Sleep Lase Repeat
Yeah, round the edges. This works fine in my projector with no issues for the 8 wires running through.
finally finished the projectors.
i wanted to take my time with this projector and get everything right and try future proof. Ive added a 5v 8amp psu for a red at some point.
inside are dt40 scanners, 1w green and 2.5w 445
everthing is mounted on two 10mm base plates
the 445 can simple be unplugged without having to go onto the botton level, so it can be removed and worked on if need be.
ive fitted 4 rubber feet
the projector is fully sealed, with rubber around the edges, dust filters on the fans and AR window
a few beam pics
little and large
![]()
Eat Sleep Lase Repeat