I have a 500mw projector, A 700w fogger, a notebook, ilda cable, a about 150m2 room, and about 100 people at a wedding where i will do the last 3 music songs with a laser show.
I basicly need advice to get the most out of this show, to make the most WOW! effect to the people who watch.
Facts:
First point: no way i want to do a graphics show. It will be a beamshow.
No divergence control, so i guess no direct crowdscanning.
No smoke sensors that react on my fogger.
Its in a closed large room with a dancefloor, stage, and lots of seats and a bar.
I will tell a savety story before stsrting my projector.
I cant hang my projector to the ceiling. It has to be on the ground/table/stage ect.
Already got permission and "a go" from the wedding master and from the room boss.
Ideas:
I now have a 500mw white rgb projector, although i can make it 1w if i turn up the 445nm, but this will ruinin my white balance.
My plan is to scan above the heads of the crowds, ofcource with some distance between beam and head. Although this messes up visibility i guess its the best way to go?
I want to place the projector on a table, on stage. Then scan with the upper part of the scan angle, and turn the other one down.
Its planned to be used during the time that everyone dances...but maybe i can ask to turn down or dim the lights for one song?
Any other ideas and suggestions?
I got till the 25th this month, then it takes place.