Hi,
Anyone know where I can tap my Scanpro20 scanner amps to get the position output signal for scan fail detection?
Domingo.
Hi,
Anyone know where I can tap my Scanpro20 scanner amps to get the position output signal for scan fail detection?
Domingo.
Hey Domingo,
Actually, I do have this information. I have been told TP5 is scanner feedback. maybe put a CRO on it and see what you see.
Dave
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Hey Dave,
Ok, thanks for letting me know, I'll check it out as soon as I get the chance, although I must admit I don't really know anything about scanfail signals so I don't really know what I'm looking for.. I'll take a look anyhow and post back my findings.
Domingo.
I seem to remember that scanfail signals are +-10V reference to ground - or at least thats what I think I remember when I enquired about getting scanfail signal off of my DT25 board. Is this a standard across scanner drivers I wonder?
Frikkin Lasers
http://www.frikkinlasers.co.uk
You are using Bonetti's defense against me, ah?
I thought it fitting, considering the rocky terrain.
Depending on how well they copied the Cambridge amplifiers, it should be .5V per degree.
Steve
Cheers guys, any info will be helpful. So I guess I'll start by running a few basic patters at diferent sizes and see what measurements I get.
Domingo.