CNI-I-OEM Driver

[dilbert]

Hi, does anybody know what the 3 adjustment pots are on this driver? Marked RP1, RP11 & RP21?

Thanks

[dnar]

RP1 adjusts the amount of do not adjust.

RP11 adjusts the laser speed of death.

RP21 adjusts the volume of "Oh Fuck".

Seriously, do not adjust these.

[dilbert]

lol I always like a laugh on a crappy Monday morning.....

Seriously though, I'm not a serial knob twiddler!!! I have a matching CNI MBL20 473nm head & PSU which has a dead pump diode. I have a 2nd good head without PSU & when I connect it runs fine for about 10 mins then drifts off so I obviously need to tune the current / TECs etc on the PSU to suit the new head and am trying to find out what the function is of each pot before i go down the trial & error route.

[dnar]

I asked CNI the same question when I got mine. The answer was simple, "it can only be adjusted in the factory".