With the greatest respect, a timer alone won't save you from over fogging.
What you need to do is start to learn the correct level through practice and experiment. With 2.5 watts you'll be able to punch through very thick fog, but it doesn't mean that the beams couldn't be brighter. In my experimentation, I found that with fog, there's a very fine line between under fogging, perfect and over fogging. Anything that falls outside of perfect starts to show a fall off in brightness and definition. The more laser power you have the less critical it is as the beams will still be acceptable for longer, but you still are under selling yourself when you beams could be brighter and clearer. Experimentation is the key so you start to recognise the optimum level visually. What you do then is set the optimum level, start your display and just top up with small amounts as and when needed when the fog starts to drop off which again you can assess by the drop off in beam brightness.
Also, a very good tip I learnt from others on here is to use a fan to distribute the fog more evenly within the room.
Best of all, if you can afford it, get a hazer. Produces much better results and can allow you to work in a room with no visible haze (although obviously its there). You can still over haze with a haze, but it becomes a lot harder as the smaller particles don't block the light as much. Also, its easier to spot because of the fact that you can normally run a very clear atmosphere with haze, so if it starts to look misty and foggy, you have a clear indication you need to back the hazer off. With fog the difference is between medium and thick fog so harder to spot when over fogging other than by observing the effect on beam brightness.



Reply With Quote
