Perfect DB25 to RJ45 adapter!

[andy_con]

received mine today also, they look really fooking nice. great design rob.

sadly i probably wont get round to testing them in the near future

[singaudio]

does someone has a scheme how to wire ILDA with RJ45 ? thanks

[gottaluvlasers]

Technically, there really isnt a "standard." You can wire it however you want. RJ45 has 8 connectors, therefore 8 wires-

1- R
2- G
3- B
4- X+
5- X-
6- Y+
7- Y-
8- GND

You would wire those with the standard ILDA pinouts of the same signals.

For example-

ILDA pin 1 (X+) to RJ45 Pin 1 (wire1)
ILDA pin 2 (Y+) to RJ45 Pin 2 (wire2)
...etc...

However, you could wire it in any fashion you want. The only "standard" you should adhere to is the ILDA DB25 connector standard.

-Marc

[djlorenz]

1- R
2- G
3- B
4- X+
5- X-
6- Y+
7- Y-
8- GND

and color -? where do you put R- G- B-? you use that 0-5V? seems bad for noise...

[hitekvoop]

For great justice, add these to your build: http://www.neutrik.com/en/ethercon/

[gottaluvlasers]

Lorenz-

Tie the - color signals to gnd.

I have only used this RJ45 connector in an absolute last case scenario for EXTREMELY long runs. And have never run into any sort of noise issues. If the projector is wired properly, you are using good components, good (shielded) cable- you really shouldnt have any issues.

-Marc

[djlorenz]

if you connect your - to gnd your ilda software that puts out +-5V gives you only 2.5V isn't it? or your gnd goes to 0/-2.5v