Andys clearout sale thread
time for me to clear some stuff out as i have to much stuff.
quad diode setup made from aluminium. not sure if someone can use this or not, it could be turned into a red and blue module
diode holes drilled for 5.6mm diodes and tapped for 9x0.5 thread
total sizes - 141.5mm long x 66.5mm wide x 45mm high
after £80 + shipping
2x round aluminium projector windows
one is 70mm dia with a 57mm dia inner
one is 49mm dia with a 39mm inner
£15 each (gee these cost me a lot)
quad 660nm red module
one or two of the diodes have gone so they will need replacing, but its only a 10min job.
apart from the diode(s) this module is fully working.
produces a 3.5mm by 3.5mm beam @ 0.65mR
142mm long x 65mm wide x 40mm high
after £300 + postage
1watt 445nm module
this is a one off module, you wont find another like this. i made it as a bit of a test module. 0 hours on the clock and fully working.
1watt at 5mm by 5mm beam @ 0.55mR
59mm long x 42mm wide x 39mm high
beam height of 16mm
made with a die4laser driver so analogue modulation. comes with a required 6.5v psu
after £300
Reply With Quote
Originally Posted by andy_con
