Few laser related items

[gogu]

ALL ITEMS SOLD
I've collected a few laser related items over the years and have not put them to much use.
Hope they'll be put to better use then sitting boxed up in the garage.

paypal and shipping (to US only) is included unless otherwise stated.

Three Thorlabs Prism mounts: Similar to the KM100P but not identical (maybe an older model) without clamping arms
$70 for all 3. (SOLD)



Five L-Brackets they're all 2"x2" with 1" slot and can accomodate up to .25 od bolts.
$25 for all 5. (SOLD)



ThorLabs BA2 Base and Post
$20 (SOLD)


20Kpps Galvo set with power supply, dmx and all necessary cables. I bought these about a year ago from LaserShow parts for $180 only took them out for the picture below.
$70 + $10 shipping (SOLD)


Two Die4Chill TEC drivers, (boards only) as shown in picture
please see post #4 in this thread: http://www.photonlexicon.com/forums/...6244#post56244
$15 for both (SOLD)


Aixiz module holders/mounts 6 square mounts that could easily be mounted on a tec, some also come with a thermistor. 2 other mounts that fit an aixiz module perfectly as seen in the picture
$20 for everything in the picture. (SOLD)



Two 445nm diodes with lens. Never used, never pulled out the anti-static baggy they came in.
$70 for both.. (closed)

[kiyoukan]

i would love the Two Newport P100-P2 mounts
But could you remove the mirror? i want to use them in my projector.
Also what glue did you use and if you got any left could i buy that with it?

[gogu]

kiyoukan,
I purchased the mounts with the mirror on it, the seller didn't pack very well and it caused the chipping on the edge.
Not sure what type of glue that is.
PM me your paypal info.

[kiyoukan]

pm sent, thats fine.

[Leonid]

gogu, I will take 20Kpps Galvo. Sending PM.

Sorry, no my interest. I didn't notice that USA only..

[gogu]

Galvos would be about $90 shipped outside the US