Hi all guyz.
Recently I refurbished an old RGY projector, putting inside a blue module. Chars of modules:
- Green: Century Laser, 532nm/120mW TTL
- Red: CNI, 650nm/450mW TTL
- Blue: Laserwave, 473nm/250mW Analogue.
Whatever figure I try to play by FB3-SE device, it comes out.....as a vertical line only.
It seems as X scanner is not working.
So I tried to play the same figure with my other device: FB3-QS and.... Holy cow!!!!! Everything works fine!!!!
This is very strange: my TTL/analogue projector does not want to work by FB3-SE device, instead it works perfectly by FB3-QS.
I also tried to change projector's setting (scanspeed, colors, modulation, etc. etc....) without any success.
Attachments here...
left picture: the "strange" line coming out when played by FB3-SE
right picture: the same figure instead correctly played by FB3-QS (please don't take a care about picture entirety, it appears not complete because shoot speed of my camera...)
My I can do something to fix this strange problem?
Any advice/help will be welcome
Thanks in advance
Steve