Sorry to add to an old post, but I ran across this nugget of wisdom while trolling for beam characteristics of various wavelengths in preparation for an upgrade to several of my RGBs. It is a simple solution that never occurred to me before

I wondered if it could be done to a 635nm beam to resolve a similar problem.
So in short, I attempted it with a situation on a primarily graphics projector that has a 635nm in I got from Marc that was doing double the power I had purchased. (Not that I looked at a gift horse in the mouth . .

I had been using adjustment pots from StanWax to cut down on the reds. Unfortunately, cutting the mod voltage by about half using this approach results in a red diode that fades to zero much quicker than the green and blues did. Resulting in an uneven fade from white to black.
So using the pinhole idea, my hope was to use this tip to cut my 635nm power by half (maintaining full analog range characteristics) and make that over-sized square beam overlapped more evenly with my tight 473 and 532 beams in the same rig. In the end I got this:
S2040004.JPG S2040007.JPG
That's a pretty nice white beam to the eye, but it retained the shape characteristics that it had before. The hole the 635 is projecting through is about 2.25mm diameter. The beam is supposed to be 4-5mm at the aperture, so I'm confused. Does a 635 tighten down a bit after the aperture and then diverge back out allowing that large square beam to get through? Also just to note, that green stripe in the picture isn't misalignment, its a crystal problem that only shows when projected onto a surface. I still need to correct or replace that problem.
Is the only solution to get an even beam overlap between 8 and 15 meters when using 473s and 532s a purchase of a 660nm red?? I was really hoping to avoid this as the 660s are really pricey and comparatively dim . . .
-David