Just a simple write-up of my first build here. Nothing fancy, but a simple 445 projector I threw together from all of the bits I had scattered around and I was eager to get photons out of the aperture.
DSC_0397.JPG
Shot of the projector from the front. The enclosure was cannibalized from a €40 LED fixture which expired its shelf life about 6 months ago. It has more than enough space for a simple satellite projector and it had some useful components that made it the perfect candidate for modification into a laser projector.
DSC_0398.JPG
The back panel has some of the original connections, including the safety cable, power cord, fuse holder and XLR in/outputs. Instead of DMX, these were repurposed to serve as a 12VDC connection from a remote emergency stop, with a relay inside the projector controlling power to the laser.
DSC_0395.JPG
There was enough vertical space inside to use a two-story layout. The optical deck sits on 4 standoffs which you can see here and the 12V and galvo power supplies underneath, together with the projector's wiring loom.
DSC_0307.JPG
The optical deck itself is nothing specifically fancy, and could probably be built a little more efficient if I put some more time/effort in, but again, I wanted this to be a fairly clean and straightforward build which worked.
The projector itself consists of a simple 20K China scanner system and a dirt-cheap TTL 445nm module which is specified as 300mW on the sticker. Right now I have no need to crank the power up more, if I upgrade this unit, I'll probably switch over to an RGB system. The only reason I didn't do so already is because I didn't have any proper dichros or kinematic mounts on hand, and cramming an RGB beam table onto a 120x120mm square might be a bit of a tight squeeze.
Again, I didn't care about building this thing as efficiently or space-saving as I could, I just wanted it to work.
DSC_0401.JPG
DSC_0407.JPG
The projector all lined up and running.
DSC_0414.JPG
Quick test to see if my graphics worked -- not perfect, as you can see (but then again, this is one insanely complex frame). The galvos need a bit of a tune, but I'm going to wait for that until I have a more sensible excuse for a DAC than just hard-wiring a sound card straight into the ILDA connector.
DSC_0415.JPG
And of course, this thread isn't complete without the mandatory scanning beam shots!
This thing is going to be accompanied by a twin sister once I can free the budget for a second laser and scanning system, and eventually the main head will have a bigger beam table with ~1,5W (600mW 445, 600mW 635, 300mW 532) of balanced RGB and 30K scanners. The satellite systems will probably stay like this until I can get some decent base plates machined for them.



Reply With Quote
