Results 1 to 4 of 4

Thread: NEC3030 laser safety

  1. #1
    Join Date
    Jun 2007
    Posts
    101

    Default NEC3030 laser safety

    Hi guys,

    I have an old NEC3030 argon ion tube laser.

    Hour counter says 8185 hours but has long since been disconnected.

    I have no idea what the power output currently is but the tube is old and sam's laser faq says..
    The tube is all glass and will do between 5 and 30 mW, depending on its condition.
    I'm wondering just how safe it is to casually play around with.
    I'd like to take it to a bonfire me and some mates are having, probably set it up to show a beam from the bonfire smoke.
    But we wouldn't be wearing safety goggles

    Anyone able to give me some indication of how much more dangerous 10,20,30mW is over your standard 5mW pointer?

    I'm used to being around 200-300mW diode lasers keeping safe with them but i'm not sure about the middle ground above your typical 1-5mW pointers

    Also, the laser does still have the built in power meter diode on it, does anyone know what the voltage to output power relationship is? If i knew that i could measure just how much power it is currently producing.
    If the output has fallen to 5mW then its probably pretty safe.

    And, before you mention it, Yes i will be putting the powersupply into a box to protect all the high voltages from being touched.

    laser1.jpg

    laser7.jpg

    laser8.jpg

    laser12.jpg

    Thanks guys
    Ben.
    Last edited by Psi; 11-28-2011 at 19:56.

  2. #2
    Join Date
    Apr 2006
    Location
    Miami, FL
    Posts
    3,590

    Default

    I would be more worried about electrical safety than optical safety...

    dont point it in their eyes, done?

  3. #3
    Join Date
    Jun 2007
    Posts
    101

    Default

    Yeah, it needs work to shield off all the mains stuff.

    I have a big metal enclosure that i plan to use which should fit all of the powersuplly inside.
    I'll probably have that enclosure on its side and bolt the laser to the top.

    Then i can route the cables inside easy and keep it all enclosed in a mains shielded box.

  4. #4
    Join Date
    Jun 2007
    Posts
    101

    Default

    I don't suppose anyone on here is in Auckland New Zealand and owns a laser power meter.

    It would be nice to calibrate the output power sensor.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •