-
Constructing a 1W 445nm TTL module
Hi all,
I am modding an 'el-cheapo' chinese RGB laser system and am looking to add a TTL blanked 445nm diode.
I already have a 445nm diode + driver in aixiz module tuned to +-1000mW that I mounted on a large heatsink with a TEC so heat issues are no problem
(I did'nt have a fancy TEC driver yet so used a thermistor that activates the TEC when module reaches >40°C :blush: )
for the driver I was thinking about the 1W o-like TTL driver (LINK and image LINK)
My question is: can I connect the power leads of my existing module (diode+driver) to the output of the above mentioned TTL driven driver OR is that driver meant to connect directly to a bare LD?
Thanks!
-
Since it reads "diode driver" I would think that it would be a direct connection to the LD. Might wanna shoot o-like an email just to be sure ..
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules