Not the best photo, however it does show the difference between 635nm 200mW and 655nm 200mW. No blanking at all in this photo, both lasers set to output max and just used pangolin to drive the scanners.
I had a bit of a problem with two of the three colors flickering now and then. I stopped using the 3 power supplies that were supplied and I am now using a 5V 20amp switching supply from www.jameco.com. So far the output has been pretty solid since using the new single supply, still testing though!But when I draw a line in Mamba, it`s some sort of flickering in the beginning..
Like it`s calibrating itself...
Maybe it`s just a minor of not been warmed up ?
I have never tryed my laser on for such a long time... so maybe it`s normal during warmup time
David