-
Laserscope Alignment ( again)
After a search through old threads, I can't find any mention of how to align these things...if you don't have the alignment optic. I spent some time adjusting the "B" optic and the KTP up-down slide and then the KTP tip/tilt and then repeating this over and over to get max green. Max is about 4.5 W CW at 24A. Any higher on the current and the heater ohms begin to drop and the power output begins to decrease. I was concerned about the spot position on the crystal ( the little window is ridiculously small and I can't tell what I am looking at through it) and so with 1064 glasses on I removed the KTP to "B" mirror tube to have a better look. Man, the tube was hot! I would guess 100 + C. However, for what its worth the mounts on either end of the tube were not hot. I then carefully placed a piece of paper near, but not in the 532 beam and it began to smolder. Its clear that the beams are not completely co-aligned. Is this normal?
Having noticed that the backstops such as the one behind the "Z" fold mirror do in fact stop a measurable amount of IR, I'm wondering if I were to remove the KTP holder, could I meter this waste to max the IR? Does the interposition of the KTP significantly shift the IR beam or if optimal before the KTP will it be close after the crystal is replaced?
The output is not bad, but I suspect it should be better. I would like to develop a better understanding at this level without necessarily learning how to completely rewire this thing, there are others here who could and my hat is off to them.
Any suggestions, links (Sam's requires 2 meters and the optic), pics? Anything would help.
-
We do not generally discuss laserscope hardware here, openly. There is a reason for that.
One specific former forum member, in fact.
A very good reason, considering the danger of prolific KTPs in less then professional hands.
And least not if we dont want jumped by DSLI-Jon, least we create another "Allen" fiasco.
(Hi Allen, know you read this, glad your growing up some)
I have not done Zs, but I have done V-folds, and the concept is similar.
You have a PM.
Dont walk your IR into the edges of the rod, bad things happen to the rod.
This is true with any lamp pumped lasers, you can blow the edges off the rod.
Steve
Last edited by mixedgas; 02-25-2012 at 22:35.
-
Hi Eric -
Is this *after* we met? What happened? I seem to remember we were seeing quite a bit more than 4-5W... at what A? At 25-26A, you should be seeing ~7-9W CW, min.. Perhaps we can do a conference-call, later...
ttyl..
j
....and armed only with his trusty 21 Zorgawatt KTiOPO4...
-
Just after. And before any tweaking. Based on Steve's note above I haven't pursued this in an open form, but as we discussed you know I have a lot of exciting ideas I am planning to follow with this laser and would like to discuss them. The pick-off mirror, Q frequency, spot size modifications and daisy chain etc. Without facilitating the the uncontrolled dissemination of the basic system, do you see any problem with this?
Yes lets talk as soon as you are available and also- PM coming
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules