O.k., maybe a little but, at least I prefaced it before posting.
I'm trying to diagnose a laser. A cheap chinese laser at that. My first. So there's some sentimentality. Stop laughing! I wouldn't really care too much but, I have a DJ friend who has been planning on buying it for home use and, it's not happy at the moment. It's a Meierlight - approximately 220mW and a couple years old. I fired it up this afternoon because it occurred to me that last time I had it out, it was only playing the built in DMX frames and not outputting an ILDA signal. I wanted to investigate that a little further plus, I needed to re-solder the internal mic leads since I clipped them putting the cover back on.
So anyway, plugged 'er in and turned on the power. A bit of high pitched whine ensued briefly. Turned it off, waited a sec, turned it back on and now, the power sort of surges with quick bursts at a regular, repetitive cycle. Click on, click off, click on, click off. The case fan starts to spin and stop, spin and stop, the lasers light up and turn off, light up and turn off. Almost like the tick of a metronome. Power on, power off, power on, power off. My first suspect thing is the power supply. First thing in the chain right? I'm willing to throw a few bucks at replacing the supply, just for the learning experience. If it's not that, then perhaps the next step will be trying to wire in a new ILDA breakout board. I've got a bunch laying around. Stop laughing damnit! So, my initial problem is figuring out what in the hell I'm looking for when trying to find a new power supply. Pic's of the existing one are attached.
IMGP4831.JPG IMGP4832.JPG IMGP4833.JPG IMGP4834.JPG IMGP4835.JPG IMGP4836.JPG IMGP4837.JPG
That's assuming you all think it is the supply. Yeah... I know. Why waste the time or the money? Truth is, it wasn't a bad little projector for beginner bedroom/basement use. And, quite honestly, I need to get my hands dirty with this stuff and, learning on a couple hundred dollar piece of crap versus making a mistake with a $1000 set of scanners or, 640nm module is a bit more palatable. And, two years ago it WAS a $600 investment bundled with Moncha 2.1.
So, am I on the right track thinking power supply? Or, is there something else probably suspect instead?
I still HEAR you snickering... go ahead. I can take it.


Reply With Quote

