PM Series laser controller

[stupidsexyflanders]

After some work with scope and meter i have found mine is (from header pin out) .Tested on analogue dpss diodes with no problems. Obviously no intensity or blanking with this controller.

1 (red stripe) Shutter
2 N/C
3 X+ (DB15 5) (ILDA 1)
4 N/C
5 X- (DB15 6) (ILDA 14)
6 RED/EFFECT WHEEL 1 . 5 volt out
7 Green 5 volts on
8 Blue 5 volts on
9 Y+ (DB15 4) (ILDA 2)
10 Ground (DB15 1) (ILDA 25)
11 Y- (DB15 3) (ILDA 15)
12 Effect Wheel button 2. 5 volt on
13 EFFECT WHEEL Button 3. 5 volt on
14 N/C
15 N/C
16 N/C

[edison]

I found this one also:

http://link.marktplaats.nl/549046280

[Yag]

After some work with scope and meter i have found mine is (from header pin out) .Tested on analogue dpss diodes with no problems. Obviously no intensity or blanking with this controller.

1 (red stripe) Shutter
2 N/C
3 X+ (DB15 5) (ILDA 1)
4 N/C
5 X- (DB15 6) (ILDA 14)
6 RED/EFFECT WHEEL 1 . 5 volt out
7 Green 5 volts on
8 Blue 5 volts on
9 Y+ (DB15 4) (ILDA 2)
10 Ground (DB15 1) (ILDA 25)
11 Y- (DB15 3) (ILDA 15)
12 Effect Wheel button 2. 5 volt on
13 EFFECT WHEEL Button 3. 5 volt on
14 N/C
15 N/C
16 N/C

Nice one, I'll keep a copy of that, I might re-purpose some of these other connections at some point!

[stupidsexyflanders]

I found this one also:

http://link.marktplaats.nl/549046280

Nice one , thanks. I think i`ll buy this one if im not to late.

[crispyhs]

i have a PM22 in good condition ...your best price !!!

Looking for a stand alone PM20/21/22 or similar to use as back up .