Well last night I managed to mess my blue laser up
I think it was because my ILDA plug was a little loose.
All three lasers (RGB) started flickering so I started checking the cables and then the blue went off.
The G+R were still flickering until I found the ILDA connector half out, as soon as I shoved it in properly the R+G came on ok but the blue stayed off.
I'm hoping it is just a fault on the blanking side of the blue as I believe they have an opto-isolator and this can pop.
Just in case anybody has any other suggestions (if I cant sort it out) please post.
Also if dave is looking in on this thread do you have any info on the dpss psu it is the same as your LP473-50, also dave do you have details of the differences between the ttl and analogue versions of the psu? I expect they are the same apart from a few front end components, or are they totally different psu boxes?
Cheers chaps
Jim
ps The alarm led didn't light, both power and laser led's do though.