DMX to TTL or 0-5v analog breakout board?

[ghostgeek]

What products are you guys currently using to convert DMX to TTL / 0-5v analog drive signals?

I'm looking for a DMX breakout board with TTL outputs to drive the interlock, actuators and other low voltage (5 - 24v) loads. I've of course seen DMX dimmer packs everywhere, but that's overkill - I don't need to switch 110v AC!

OR... is there something out there that goes from DMX 512 to 0 - 5v analog? That would be nice for controlling lumia and diffraction grating wheel speeds.

[taggalucci]

Try lasershowparts.com or contact "dave" here on PL. Even a search here for "DMX" will return you some useful info.

[KGB]

I've had Daves 16ch DMX to TTL board running my beamtable for over 2 years now. Never failed me

http://lasershowparts.com/store/inde...d&productId=80


-Brooks

[dave]

Hey,

I have a few things

The DMX16 which is a 16 channel DMX-TTL convertor board. I'm just waiting on some parts to finish off a small run of 8channel DMX- 0-5/0-10V analogue boards, and I also have a constant current actuator/small motor driver that has damping.. This one mates with both the above boards.. I also have a single channel and 8 channel DMX relay board

[ghostgeek]

Sweet Dave! When will the 8 channel DMX 0-5/0-10V analog boards be available?