Calling LivePro guru's...

[Bradfo69]

I'm a little stumped here. In setting up for a show last night, I was going to use LivePro for the FB3. This is a relatively new install of the software and I can't say for certain that I've had it hooked up to a projector yet. Anyway, my setup was: control computer out through a 75' ILDA cable to a Kvant Spectrum, then through the ILDA passthru 50' to another Kvant Spectrum.

When setting up my projection zones and going through test patterns, I was getting white output and colors appeared as they should be. Once I would start actually selecting cues, I would lose green. And any attempt at manipulating the green with any type of contol did absolutely nothing. I flipped over to another computer with LivePro with my QM2000 and everything was fine. I switched over to Quickshow on the same computer I had the LivePro for FB3 and didn't have any problems either. Just the cues in LivePro. I've checked everywhere I can think and don't see anything amiss. Any ideas?

[norty303]

What version of Livepro are you using and which type of FB3?

[Bradfo69]

It's an FB3 QS and as far as the version, that will have to wait until I go to work this morning, as it's on my computer there. Gimme an hour and a half or so.

[norty303]

If it if before build 2014 or so then an update to the latest version should fix it.

[Bradfo69]

It's version 5.01 Build 2007

[Bradfo69]

That seemed to take care of it.

Thanks!

[norty303]

Cool. There was bug with the initializing of QS boards which a few of us here helped identify last summer.