Do you think I should try those 100mm and 75mm lenses to fold the beam of my red laser? I've tried to make the beam as small as possible with the corrective lenses but still loose about 40% of the power after the 5mm mirrors on the scanners.
Do you think I should try those 100mm and 75mm lenses to fold the beam of my red laser? I've tried to make the beam as small as possible with the corrective lenses but still loose about 40% of the power after the 5mm mirrors on the scanners.
Are you using a quad or dual or single diode set up?Do you think I should try those 100mm and 75mm lenses to fold the beam of my red laser? I've tried to make the beam as small as possible with the corrective lenses but still loose about 40% of the power after the 5mm mirrors on the scanners.
before i buy any can you confirm i have the right part numbers please
450nm one , NT69-887 .
550nm one , NT69-900
in th uk price is £79.00 or $126.00
When God said “Let there be light” he surely must have meant perfectly coherent light.
Right now a single diode, but going to upgrade to a dual soon.
No. Actually the ones that I believe are identical with the Semrock models are:
NT 86-390
NT 86-393
These are a little more expensive. I don't know how the other models you list compare. They might be excellent, I just don't know.
dam wont be buying them just yet eek 140.00 GBP = 224.091 USD
the uk edmunds is just to expensive me right now , trying to save for a 2w 532nm
thanks for the part numbers planters
When God said “Let there be light” he surely must have meant perfectly coherent light.
OK. With a single diode or if you someday upgrade to a dual with a PBS/waveplate the size will be identical. Because you have a single stripe then all you have to do is reduce the width of this stripe. The already 2-3mm height will not present a problem fitting on a 5mm mirror at a 45 degree angle of incidence. The best, lowest cost and lowest loss solution would be to place the first cylinder lens in the expansion pair, closer to the diode and refocus the second cylinder to a smaller near field beam size. There is nothing wrong with moving this pair closer or farther from the diode to re-size the beam. The only down side effect is that the divergence will increase proportionally as the beam size is reduced and no combination of beam manipulation-optics will change this optical property.
planters could you please look to see if any filters on this site may do ?
http://www.longpassfilters.co.uk/
many thanks
When God said “Let there be light” he surely must have meant perfectly coherent light.
I do not think so. As I read it, these are absorption glass medium filters as opposed to reflective dielectric filters. If you are looking to find an alternative to the costly filters above there are so many suppliers it is daunting. You might consider using the smallest diameter that will clear the beam or just use say one filter ( the one most down stream) this way at least all the lasers will benefit from the upgrade as to only two.
Thanks for looking planters , in my projector i have the red nearest the scanners then blue ,then green
The refelect red dichro is a newer laserwave one, and is good at passing green and blue the reflect blue one is not so good
At passing green ,so thats the one i would replace , would the 466 filter be ok to still use as mine are in a different order ?
Sorry to ask i am crap at opticscan build modules ok though
When God said “Let there be light” he surely must have meant perfectly coherent light.