Ok, So I have tried setting the laser in a heated room for a few hrs and didnt see a large improvement. I then removed the lid, disconnected all of the case fans and started getting everything nice and warm with a hair dryer. WOW what a difference. The output on the blue has doubled. I am now gonna add a switch to kill the fans externally as well as the above mentioned heater, looks like this will be the only way to go.
@ Mof, the green does perform a little bit better at 100%, but it seems like there are some cooling issues still. seems the TEC is turned up a little too far. The laser starts off dim, then after 2-3 seconds increases in output by about 40%.
I had posted a few weeks ago about pot identification on my driver boards. I have found the identification and spent all night tuning the drivers. 18C ambient, no fans. Now Getting equal output from all diodes @100%, and an amazing color balance. was actually able to turn down the current on all diodes by tweaking the TEC settings. blue is down from 450mv on the shunt to 308mv. and I am getting an additional 40mw of output
I have now run into another problem tough. Maybe a serious one.Starting a new thread for that.



Starting a new thread for that.
Reply With Quote


....and armed only with his trusty 21 Zorgawatt KTiOPO4...
