CNI Driver Trimmer and pin problems

[matratzki]

Hi guys,

I got an old Quantum Laser with a broken driver, so last week I bought an used CNI driver to power and test the quantum head.
So I asked ayuki from cni for some technical data including trimmer and plug assignment and which temperature sendors I should use with this driver.
He replyed, that he can not send me any informations without knowing the serial number (which is not written on the circut board).

Does anybody have the same driver at home and knows the correct trimmer assignment and the connector for modulation and Temp sensors and which Temp sensors I can use (NTC/PTC...10K...20K)

Best regard
Mathias

[LaNeK779]

maybe this would do?

http://www.photonlexicon.com/forums/...7&d=1324471350

i can notice some slight differences, but i am not too sure what to make of them...

[matratzki]

thanks for your reply
i found this post already, but as you mentioned the layout is a bit different to my one.
Propably someone uses the same driver.