Hi could someone please explain how to wire from an ilda breakout board to the galvanos and red green and blue ttl lasers. I al not sure what pins exactly go to what. Thanks!!!
Hi could someone please explain how to wire from an ilda breakout board to the galvanos and red green and blue ttl lasers. I al not sure what pins exactly go to what. Thanks!!!
Try here.....
http://www.laserist.org/StandardsDoc...finaldraft.pdf
and here.....
http://s80.beta.photobucket.com/user...LDA-1.jpg.html
10W RGB
2x 5W RGB
2x 3W RGB
2x 1W Green
---------------------------------
QM.NET, 2x FB3, LivePro, Beyond, APC40,
kgblasers.com
Could someone please include a pic of what you might consider a standard ttl laser module and describe the hookups for it. Thanks!!!!
Maybe if you tried taking pictures yourself? Someone might know what goes where.
Maybe the attached image will help? Being TTL lasers, you may need to run "GND" to the modulation inputs as well. Just curious, what type of breakout board are you using?
Breakout board_RGB_Setup.JPG
I have not ordered any board yet but plan to. I am right now just trying to get everything planned out before i order anything that would be specific to a certain way of wiring.