VRAD actuator mounting bracket

[ekeefe]

Hey guys,

I just bought a Pangolin VRAD actuator to play with.

Does anyone here make/sell mounting brackets for it?

ED

[andy_con]

http://www.photonlexicon.com/forums/...olins-Actuator

[ekeefe]

Thank you!

PM sent...

[Jem]

Andy was making the mounts for me. They're really decent brackets although i've since discovered that the slot could do to be just a little wider. Wasn't a problem though as I just ran a slightly wider slot drill through them . Might be worth mentioning to Andy though if you're thinking of having some made.

Cheers

Jem

[ekeefe]

Hi Jem,

Thanks for the tip.

ED

[andy_con]

from memory jem it was 4mm wide, how wide do you need it?

[Jem]

Hi Andy

For the breadboard I am using for this particular project I upped it to 5mm. However, it might be worth making the slots clear an M6 as this should cover most eventualities.

I blame myself for this error as I didn't specify clearly what I wanted. This should be no reflection on Andy's workmanship which was spot on

[andy_con]

6mm geee.....

you will be able to put ya finger through the hole its so big

[Jem]

Well, if it's a metric breadboard (of a reasonable size) it'll probably take M6 Hex Bolts. The small breadboard i'm using as a beamtable is imperial and measured in them old fashioned bits of inches thingies

[andy_con]

fury muff !