Results 1 to 3 of 3

Thread: How can this be done ??

  1. #1
    Join Date
    Aug 2010
    Location
    Belgium
    Posts
    295

    Laser Warning How can this be done ??

    Hi all,

    I installed a blue diode instead of an poorly visible blu-ray diode in a cheap RGB laser.


    After the upgrade and alignment, I opened Quickshow to test the modulation and display some frames. Then I plugged the computer charger.

    And here is what I obtained, when zero beam should be displayed :

    http://youtu.be/3OLKBAM76aQ


    I though there was a kind of isolation in the FB3 between the USB and DB25 output !


    Driver : Flexmod P2
    Computer : HP touch smart TX2
    This problem happens only on the blue channel, no problem with green and red.


    Thanks,

    Mike

  2. #2
    Join Date
    Dec 2008
    Location
    Vezon, Belgium
    Posts
    1,017

    Default

    Hi Mike ^^

    Grounding loop problem, try disconnecting ILDA ground from the DB25 and go fully diferential

  3. #3
    Join Date
    Aug 2010
    Location
    Belgium
    Posts
    295

    Default

    Ok thanks for the advice

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •