Hi,
I have been asked to research and prototype a bit for a possible laser installation.
The installation consists of a clear plexiglass window (or actually several windows) with a shallow black box behind. Inside it is a classic laser "fan"-type effectpointing upwards, the beam termination can't be seen, just the fans through some smoke. So far so good, no problems.
The thing is that it has to be a closed system, no smoke can escape into surrounding air!
I tried a simple mockup using 12k scanners, 50mW 532nm laser, cardboard, a free running DMX-board and some plexiglass. And lots of scotch tape!
I used a Thomann.de cheap hazer with a silicon hose for smoke delivery and a small computer fan to push the smoke up and make some movement. It worked surprisningly well, a very short burst of smoke sits for a very long time and produces a nice effect, like a rave in a picture frame!
Here are pictures and videos of my tests.
Earlier static beam, it's a real masterpiec of scrapheap engineering!
With scanner:
Video with lights on:
https://www.youtube.com/watch?v=p4Ubjmf40bU
Longer video with lights off:
https://www.youtube.com/watch?v=Od40_hoMLA8
I can have the designer make the cabinet almost airtight and I thought of having only one vent in the whole system let all air in & out pass through some type of air filter. Due to the very small amount of smoke it could work by using a slow moving computer fan to just circulate and add very little some every 10 minutes or so.
Do you guys think it would work? The thing would be run for like 6 hours at a time tops.
The only problem I can think of with the smoke/haze would be contamination of the acrylic windows, is that a problem you think?
I am using glycerine smoke fluid, is ther other techniques to produce smoke that might be better for this?
And no, lcd-screens with video is out of the question!![]()





Reply With Quote
...so you could just use a tiny 20-50mm fan internally to give some movement of the air maybe, rather than having airflow through the cabinet?

