So after my scan angle once halved and my blue stopped working of my first ever laser projector I finally re-organised the wiring and fixed the ilda connector (where bad connections where the cause of the problems) and also shrink tubed all connections to the DB25 connector.
Having "almost" all problems fixed (Blue works again, scan angle is full again) I have 1 problem left: My red.
It modulates well and blanking works fine but it's very dim.
Here is a picture of it:
The driver is Die4Drive and I believe these are 2 650nm diodes.
Adjusting the pots carefully does make a little difference in intensity but not by a whole lot it's still very dim.
I'm assuming is not that it's a power problem but a focus problem (see the pictures below why I think this is the problem) It could also be a power problem though (I'm about to measure the psu for red with my multimeter).
Here a few pictures:
*The red in this picture below is coming from the lighting in my room, I have the projector off when I took this picture
Any idea's what to do?
Edit: Measured the psu voltage going to the driver.
It's 3.587 Volts *when the PSU is completely turned up*






Reply With Quote
(this was a good warning a while ago from dimitri)

