Hi Folks.

My name is Philipp Maier, I am an ongoing electronics engineer and i have little big problem...

Some time ago i got an Adlas DPY 325 II. Unfortunately without the cable between the controller box and the laser head. Nothing easier than that i thought by my self. I bought the matching connectors and opend the laserhead and the controller box. Oh no! i thought by my self. There wiring inside tha head is completely wiered and after looking at the pcb inside the controller box (which is decorated with lots of bodge wires by the way) i pointed out that the pinout never can be 1:1 and i can not see any systematic in here.

This is the schematic i have drawn:
http://pub.runningserver.com/dpy/all_i_know_is_this.png

Here are some photos:
http://pub.runningserver.com/dpy/

And this is the "Wanted Letter"
http://pub.runningserver.com/dpy/wanted.txt

I have checked everything on the internet including sams laser FAQ - no success yet!

I am aware that the chance that this laser is broken (pump diode or something similar) is quite high as it was sold to me as a junk piece. But before i take it apart i want to know that for sure. So if you work with such a device or even own one. It would be very kind if you could take a multimeter and measure the cable. The first one that sends me a pinout that enables me to make the damn thing work will get a surprise ;-)

regards.
Philipp