Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Laser diode voltage, how important? Driver recommendations?

  1. #11
    Join Date
    Apr 2008
    Location
    DC/VA metro area
    Posts
    425

    Default

    But I'm not loosing brightness by running it at 1.5vdc @ 250ma versus the mfg spec of 2.5vdc @ 250ma right?

    Wired it up to the flexmod.

    Red running (still have green dpss trails, need to order that DZ color board.)

    http://www.youtube.com/watch?v=rbHgw...ature=youtu.be

    (Video goes up to 1080)

  2. #12
    swamidog's Avatar
    swamidog is offline Jr. Woodchuckington Janitor III, Esq.
    Join Date
    Nov 2006
    Location
    santa fe, nm
    Posts
    1,545,836

    Default

    hey LSX!

    you should be able to clean up those green tails quite a bit by adjusting the scanning optimization settings.

    Quote Originally Posted by telmnstr View Post
    But I'm not loosing brightness by running it at 1.5vdc @ 250ma versus the mfg spec of 2.5vdc @ 250ma right?

    Wired it up to the flexmod.

    Red running (still have green dpss trails, need to order that DZ color board.)

    http://www.youtube.com/watch?v=rbHgw...ature=youtu.be

    (Video goes up to 1080)
    suppose you're thinkin' about a plate o' shrimp. Suddenly someone'll say, like, plate, or shrimp, or plate o' shrimp out of the blue, no explanation. No point in lookin' for one, either. It's all part of a cosmic unconciousness.

  3. #13
    Join Date
    Oct 2012
    Location
    Germany
    Posts
    1,550

    Default

    ... if you receives power dropping when reducing the voltage in a current regulator driver, then you've undergone the needed min. voltage level.

    I'm driving my diodes with current regulators assembled with more parallelized LM338 and LM317 with currents from 1Amp to 9Amps - my PS has to deliver the needed current and a voltage at this current of min 6Volts or it doesn't give the set currents to the diodes, so they'll dim ...

    Viktor

  4. #14
    Join Date
    Jan 2007
    Location
    Florida
    Posts
    4,382

    Default

    Laser diodes do not behave as a purely resistive load. They can and will suffer from thermal runaway (so I've heard, I've never run one voltage-regulated only)

    Quote Originally Posted by telmnstr View Post
    But I'm not loosing brightness by running it at 1.5vdc @ 250ma versus the mfg spec of 2.5vdc @ 250ma right?
    If you increase the voltage, the current will increase. Ohm's Law. limit the current to the diode correctly, and the voltage across the diode should be right on spec (unless something is very wrong :/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •