I need ISHOW DAC info!!!

[A1pyro]

Hi all,
Does anyone have any idea on both ISHOW DACS versions, What pins on ILDA 25 pin connectors are actually being used?

[epyn]

X - pin 1. + GND (or pin 14)
Y - pin 2. + GND (or pin 15)
Intensity (for single color laser) pin 3. + GND (or pin16)
RGB 5/6/7 +GND (or pins 18/19/20)
GND - pin 25
This is the standard single ended ILDA db25 connector pinouts.
Every ILDA DAC uses these pins by default.IShit also does.

[A1pyro]

Ok I got everything to work ok with my RGB laser, But trying the same cable on my green laser I can not get the laser to turn on. I can see and hear the galvo's moving when I change from pattern and graphics but no laser output.
Anyone know why that would be??

[dooiespons]

First test if the cable is good, check if you can get a signal out of the pins.
Pinout is here:
http://laserpointerforums.com/attach...-rgbpinout.png

On the other side, ishow is a very bad piece of software, i never used it myself but i heard that it is VERY unstable. And it doesn't even work on a 64bit system (and almost every pc runs 64bit since a few years.)
Also it only does TTL blanking, so you can get no more than 7 colors out of it.