Dual driver now in stock at Lasershowparts

[Datsurb]

Noob`s question: Is it possible to use this driver for two different diodes. (A 445 and a 650).?
Different voltage and current on each channel?

2 amp pr channel is more than enough for my build. Need to save space.

Datsurb

[absolom7691]

Short short answer, yes.

[m0f]

Nice pricing for a dual w/ beam suppression. Looks like I will be in touch soon.. Also in need of a few other bits

Can they be run 'bridged' to get more current for the 9mm diodes ? Or really well heatsinked and pushed a bit harder ?

Miles

[dave]

Top current should be kept to <2.2A.. If the sense resistor was changed to a higher power resistor, they could go higher without problems

Dave

[dave]

Now with 10 turn trimpots - add $5AUD to total cost for these!