Results 1 to 3 of 3

Thread: OPT G100 laser?

  1. #1
    Join Date
    Aug 2013
    Posts
    2

    Default OPT G100 laser?

    Hi all,

    I just received an OPT G100 laser from Golden Star Laser but can't seem to get reliable information from them, so I was wondering if anyone has experience with that laser?

    Specifically, I'm wondering what power it expects? 110V AC? Some DC voltage? If it's DC, what would be the polarity (see attached photos)?

    Also, there's a connector inside the power unit (see other photo) which is presumably for modulation, but it doesn't mention what's the polarity - anyone knows? I didn't receive any cable for the modulation... Also, does anyone know which model of (female?) connector I would need to connect to that (male?) plug?

    I've also attached a photo of the label - there's a handwritten "A" on there. I assume that means it's setup for analog modulation (which is what I asked for)?

    Thanks in advance for any help!
    Attached Images Attached Images

  2. #2
    Join Date
    Aug 2013
    Posts
    2

    Default

    Also, I removed the PSU/driver cover, and it says "INPUT: 85-264VAC" (see photo). Can that be trusted, or is there some specific voltage that I should be using to power it?

    Thanks!
    Attached Images Attached Images

  3. #3
    Join Date
    May 2009
    Location
    UCSB
    Posts
    715

    Default

    The blue/brown wires are definitely AC input, and like the label says it should run fine off 110v or 240v. As far as the connector, most of the lasers I have had the + on the left (as oriented in your picture), but your luck with vary... With any luck there will be some voltage coming back out on the connector, so if you put a voltmeter on it and find that one of the pins is already at a higher voltage then the other it is probably the +

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •