Results 1 to 5 of 5

Thread: How to communicate with YLP series IPG laser?

  1. #1
    Join Date
    Sep 2013
    Posts
    6

    Default How to communicate with YLP series IPG laser?

    Hello! I want to read the status and alarms from YLP series IPL laser. Laser starting, but after 1 to about 20 seconds switch off laser beam. After reset( switch off power and switch on) starting again. How read data from YLP via rs232?
    Last edited by Automatos; 09-30-2013 at 00:50.

  2. #2
    Join Date
    Oct 2012
    Location
    Germany
    Posts
    1,478

    Default

    ... I have an YLPM-16-TP - here it's a special data packet format with data-load count and checksum used for the communication (pushing and/or polling) with the laser :-/

    Viktor

  3. #3
    Join Date
    Sep 2013
    Posts
    6

    Default

    Hello!
    I was able to connect with the YLP with commands from http://sparkycnc.com/pdfs/YLP-HP.pdf and laser cerrectly reply.
    On page 23 of this pdf is return value interpretation for command $11. unfortunatly bit nr 15 is "reserved"-somebody know what is this warning?
    regards Krzysiek

  4. #4
    Join Date
    Oct 2017
    Posts
    1

    Default

    Hello, i bought fiber laser source 20 w , YLPM-16-TP
    How can i start work? What i need?

  5. #5
    Join Date
    Sep 2013
    Posts
    6

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •