Quote Originally Posted by robotarmy View Post
Hey guys,

Just did some 'cover-off' videos of the new SL 1310 www.rlab.org.uk bought to run up our selective laser sintering, laser welding, laser cutting, laser blastering, smoke making power burning boiler etc setup.

I've got the manual, I've got 3-phase almost wired in and plumbing almost done...now it's time to figure out how to use this damn thing! Really just looking for any advice anyone can give me about what to expect from this beast of a thing, and where to start with dusting it off and getting it running (what to watch out for etc)

Haven't played with a YAG like this before, so I'm a bit apprehensive, and it's also going to be the most powerful laser I've ever played with if it works, so I'm trying to go slowly and make sure I don't balls this up.

Also, I'm wondering how the hell to identify the deionizer filter cartridge and the particle filter cartridge that I need...there doesn't seem to be any info in the manual about part numbers. The DI one has a cartridge in it that I can photograph, but the particle filter one is empty...any ideas guys? Length and diameter good enough to start? What do I need to measure and who do I need to buy one from?

Me rambling:

http://www.youtube.com/watch?v=uARkfMNmz_c
http://www.youtube.com/watch?v=chhprsXnOGM
http://www.youtube.com/watch?v=CKI8TGVdUcw

hi, i have bought the spectron Cw600 and Cw200 and all cabling . I need help with the connections. The lights ,modultor,, and ,,erxternal,, are always on, any ideas ??