Quickshow frame initiate without waiting for last frame to complete

[laserLips]

Hi, I have a question about quickshow. Sometimes I like to turn the scan rate and animation speed right down to produce a flickering effect on a semi complicated frame.
But as the song I'm doing it to reaches its climax and the beat drops back in and I hit another frame to go with the tune, it doesn't go straight to the next frame until it has finished drawing all frames in the current que.
Is there a setting to make it go straight to the next que even if it hasn't finished drawing all the frames in the current que? Or is this a buffer issue that resides in the fb3?
Thanks.
Graham

[JD3]

do you have transitions turned off? It should just snap over to the next frame as soon as you select it.

[JD3]

Could have something to do with the animation speed being down. Have you tried clicking live control reset at the same time you select your next cue?

[laserLips]

Hi guys. It's to do with the animation speed. I turn it right down sometimes to get flicker...looks good sometimes, so the animation is still running all it's frames until it finished and then goes to the next one I click but is there a setting to say just stop showing those frames and go to the next que....Bill has responded and suggested posting on the pangolin forums and I have...I think it will need the programmers involved to change it....anyway posted here also as the response is faster

[-bart-]

Allthough not connected to the animation/scanspeed.

Have you checked the soft start/end option at the cue appearance at the dynamics tab ?