Beyond Cues

[JD3]

Instead of jacking someone else's thread id figure id start my own to get some feed back

https://www.dropbox.com/s/6zplv4fsky...Hot%20Cues.rar

20 something frames for beyond, 2 or 3 aren't finished and a few are very simple beam sweaps

What you guys think?

[JD3]

anyone check them out? haha

[absolom7691]

I have downloaded them but cannot seem to carve some time out. Work has me swamped. I am looking at several days off for Thanksgiving to play with my lasers. I'll probably get to them then. I haven't even had a chance to check out Jem's either. Thanks for sharing your work, BTW!

[JD3]

haha no worries! i know how that can be

[Bradfo69]

^ What he said.

I've downloaded these and Jem's but (for example) Thursday was an 18 hour work day and then, I was back less than 6 hours later and did another 17.5 hour day yesterday. Today will only be about 13... In the down time, I've been programming a little and didn't think to go back and look at these.

[JD3]

https://www.dropbox.com/s/s74ifg6w4p...new%20cues.rar

Here's three more i made last night. Kinda proud of these

[-bart-]

keep on going !

Positive Feedback:
If you want sharp color transitions select [discrete] instead of [gradient]. That way you don't have put color keypoints ontop of each other.

Your cues still look like they have some serendipity-factor in them (probably like most starters)

Try more to create a cue in you head, and then reproduce it in Beyond. That way you end up creating the things that YOU want, faster and more accurate.

[JD3]

I created all of these with a few things in mind. Overhead non-audience scanning beams shows


I was using beyond enhanced reality preview with three projectors.

Some of these are for a single projector only.
Some are for dual projectors
Some are for dual inverted projectors.

Also I don't like my cues to be overly complex because I like to manipulate all of them live with my APC 40

Thanks for the feedback

- - - Updated - - -

I created all of these with a few things in mind. Overhead non-audience scanning beams shows


I was using beyond enhanced reality preview with three projectors.

Some of these are for a single projector only.
Some are for dual projectors
Some are for dual inverted projectors.

Also I don't like my cues to be overly complex because I like to manipulate all of them live with my APC 40

Thanks for the feedback