option b - standby beam suppression kit
This means that you need to modify hardware
option b - standby beam suppression kit
This means that you need to modify hardware
Hello,
Thank you, "swamidog" and "Bbe".
I have those resistor values on hand. I will modify one of my 3.3 flexmods and see what happens.
I will post my results.
ED
Hello,
I wired the two resistors just as described in the manual (and picture I posted). I put my meter set to Amps in place of the diode, modulation to ground and powered up at 12VDC.
The "Red "Error" light was on. I had the Bias set to 30mA before the modification, it now reads 18mA with no adjusting. I moved the modulation line to V+ and the current went up to 135mA which is 15mA lower than I had it set previously.
With the "Error" light lit, I decided not to put a diode on the output.
Not sure if a firmware change is needed or not, but with the modulation connected to ground, I was still getting current through the diode leads.
I will order one of the "Standby beam suppression kit" version from Innolasers and see if that makes a difference.
ED
No miracles. Or it's the incorrect firmware or you make a mistake in the circuit
I wonder can i install my own firmware onto FMP3 (licensing aspect)?