Scanner mirrors

[wes702]

Broke off one of my 7mm scanner mirrors and looking for a replacement ..needs to be approx .5mm thick..

[swamidog]

try onestoplasershop.

http://www.onestoplasershop.com/

Broke off one of my 7mm scanner mirrors and looking for a replacement ..needs to be approx .5mm thick..

[KyleQI]

i could provide,but i'm in china,is it possible???

[KyleQI]

is this u r looking for???

[buffo]

No.

He said scanner mirrors, not anamorphic prisms.

[dsli_jon]

Hi wes-

Broke off one of my 7mm scanner mirrors and looking for a replacement ..needs to be approx .5mm thick..

What galvos are these for? CT? EMS? DT? I have some spare-spare 7mm ap. mirs for EMS and CT.. Sounds like yours are the thin 'chivo's'? Lemme know...
j

PS - You might also see this 'article' / diag, first..http://www.photonlexicon.com/wiki/in...air_Techniques / http://www.photonlexicon.com/forums/...0&d=1370973403 ...perhaps there's hope for 'using what you have' if you have a hard-time finding OEM-replacements (?) Just a thought..
j

[wes702]

Actually both..bought 2 pair of prisms off ebay but the Gdamn things were epoxied in place...yea the wrong place! Pissed..Now i have to get more..The universe is making this hobby a bitch..

[wes702]

Being a Chiprojector, the scanners are unknown. Yes, thin mirrors..i did find some "reasonable" ones in china but they are 12x7x1mm, which would entail a bit of mods to fit...until i buy a pair of new galvos. What are chivos? $ Thanks

[polishedball]

Actually both..bought 2 pair of prisms off ebay but the Gdamn things were epoxied in place...yea the wrong place! Pissed..Now i have to get more..The universe is making this hobby a bitch..

Just bake them or use a paint heat gun stripper. They will pop right off epoxy

[wes702]

400 deg at 15 min and plop, off they came. The cold water to cool them was another story...