Results 1 to 4 of 4

Thread: Sound proofing an N2/TEA?

  1. #1
    Join Date
    Jun 2010
    Location
    USA
    Posts
    310

    Default Sound proofing an N2/TEA?

    For those here who have built an N2/TEA, I am looking for suggestions for sound proofing one.

    I have been waiting too long to build one of these as a dye pump source, and I'm sick of not having one.

    However, I have thin walls, and baby ears. If there's a way to sound-proof these to a point where I don't need hearing protection, or at least my neighbors won't hear it, I'd love to hear it (no pun intended).

    Thanks!

  2. #2
    Join Date
    Mar 2006
    Posts
    2,478

    Default

    A good, and cheap way is to use rubber coupling mounts to a metal frame, with plywood walls and acoustic foam tiles glue-sprayed onto the inside walls. Allow enough room for ducting cooling air. If you can make the walls non-parallel easily, do it. I used this method to silence a large computer while still allowing plenty of airflow. The acoustic foam is critical to damp HF sound effectively. Those tiles are also legally required to be flame retardant, so that will be useful to you, possibly... I used the thick tiles, but you may get by with thinner stuff as small electric arcs won't have much LF noise.

  3. #3
    Join Date
    Jun 2010
    Location
    USA
    Posts
    310

    Default

    That sounds like it'd do nicely, and can be done on a small scale as well as long as all the "guts" are mounted well.

    Thanks! I'll look into that for sure!

    This will likely be my next project after this DIY CO2

  4. #4
    Join Date
    Mar 2006
    Posts
    2,478

    Default

    Good luck with it. I'll dig out and post a picture of that computer cabinet if I find it, and attach it to this post. it might help a bit, anyway.
    I just mounted a shelf, then sat the computer on that. Nothing to stop a permanent mount of laser to shelf though..
    I ought to mention that the rubber couplings are usually termed 'anti-vibration' mounts. Google's a bitch till you know this.

    One other thing, maybe useful for arcing lasers: I used gluespray to lay aluminium foil to stop RF propagation into or out of the sides, top and bottom of the cabinet, grounded it to the frame and glued the foam onto the foil. If your neighbours value their TV and radio they might like this too.

    Some detail not visible: Under the shelf there is a plywood floor with 25mm of flat acoustic foam. The air comes up by convection through a gap at the back, where ideally there should a be a letterbox-type draught excluder brush to block air at shelf height and make it pass the other edges of the shelf, then the rear hatch has a gap at the top to let air out. The front can be sealed. Despite the height being low compared to the width, cooling is very effective because a hot computer causes enough convection. (Weirdly, I figured out the air draw pattern based on a fairly shallow wood fired kiln I kelped build as a kid). In my cabinet that draft-excluder brush isn't there, so it never worked as originally planned, but it cools so well I never had to. It's much quieter than a whisper when closed.
    Attached Images Attached Images
    Last edited by The_Doctor; 01-08-2014 at 17:58.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •