DT25 power supply

[neutrino]

Hi all,

Does anyone know if the DT25 can be run of a ±15V power supply? I have a set on the shelf without the supply and I want to use them in my full diode RGB but am struggling to find a ±24V supply.

Any ideas or suggestions? Space is very tight.

Cheers
Rich

[epyn]

Minimal voltage is ± 18-20V,because the amplifier board contains two 15V voltage stabilizer ICs for the opamps( from the main power supply voltage)
But if your ±15V PSU is an smps(switching mode PSU) might there will be a potmeter on its board.Clamp a voltmeter and turn up the output voltage near ±20V.


Or buy two single rail 24V at least 50W PSUs,than connect them this way:
http://www.photonlexicon.com/forums/...824#post260824

[neutrino]

Thanks epyn,

I have ordered 2 24V supplies and will run them in series.

Cheers
Rich