Hi!
ihave problem,I have projector that you want to configure.
I tried to adjust his people, who had no manual. and did not know the purpose of each resistor, ie twisted them all in a row.
I downolad manual DT40 PRO and started to act In accordance with the procedure Adam Burns - Scanner Tuning Tutorial.
But in manual marked only LF DAMPING and SERVOGAIN.
after the setup procedure according to the method. still some distortion on the X axis at any angle.
Then I changed to cable from scanners to drivers, but this was not successful.
Give me advice, what my next steps? how to make adjustments in such cases?