Got a couple of builds on at the moment.
someone wanted a custom build, but one off designs are a pain in the arse. so I spend a fair amount of time designing a case that would fit my needs also. the case is two levels as most are, lasers on one, psu's on the other.
fan cooled, but sealed housing. fans are temperature controlled
screen displaying temperature of each module and base plate on back of case
XY flip
robs ilda interface board/safety board
Edmund optics AR window with aperture mask
the photos below are of the one off build im doing, but the one im doing for myself in exactly the same case is a 12w RGB. 4w of each colour, using a 4w RGB lasersystems red
just waiting on the rest of the case to be machined, am not doing it myself this time. fingers crossed I can pick it up this week and then get it powdered coated
ive just machined all the bits that go on the case and in the case
it measures 350mm wide by 250mm deep by 300mm high
I recon the case is good for 15w of RGB
enjoy