Results 1 to 1 of 1

Thread: FlexMod P3 Problem

  1. 02-17-2014, 14:31 #1
    digger
    digger is offline Junior Member
    Join Date
    Jun 2013
    Location
    Georgia
    Posts
    4

    Default FlexMod P3 Problem

    My FlexMod P3 is set at 200 ma threshold and 2 amp max. Mod signal varies between 0 and 5 volts from encoder. My problem has developed where with the any mod signal (0-5 v) applied the amp reading remains constant at 0.7 amps. It should increase from threshold as signal increases. Any suggestions/recommendations on how to troubleshoot?

    **** Problem solved. Jumped mod ground to power ground and now amps increase with mod signal. ****
    Last edited by digger; 02-18-2014 at 06:28.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules