I have been putting some hours into my Xinyulaser RGB projector in a vain attempt to make it better than when it was shipped to me. So far I have changed the dichro mirrors and mounts, the complete scan set and PSU's and am waiting for a replacement 635nm LD to turn up. I have also had to add a small -15 - +15v PSU for the DMX pattern board as this was powered from the old scanner drivers but with them being replaced for the Laserworl set, this was no longer available. The dichro mounts and dichro's are from the Mliptack (Bridge) GB and the scanset is a Laserworld 50Kpps set. I am hopefully going to do some test pattern testing this evening with pics of the outcome.
More pics of the build up to follow later also
Any + or - comments appreciated please
Thanks
Jim