Results 1 to 3 of 3

Thread: CNI MGL F532 - 2W Laser head - Help

  1. #1
    Join Date
    Dec 2007
    Location
    Denmark
    Posts
    115

    Post CNI MGL F532 - 2W Laser head - Help

    Hi


    I asked CNI, they are normally nice to answer us, and reply with a datasheet. But asked twice without any answer from them.

    I'm going to open this CNI F 532 - 2 watt head. (have IR glasses and a clean box with hepa filters).

    - How much power to expect from the IR Diode ?
    - How much Current is needed to run the diode ? (i checked the current now, and it's 4,6 amps)

    The head only do 50 mw output of 532nm. I checked all surfaces on Vandate and KTP/LBO all looks fine.

    Any experience here ? :-)

    /Poul
    http://www.photonlexicon.com/forums/...cons/lwarn.gif

  2. #2
    Join Date
    Aug 2013
    Location
    Vilnius, Lithuania
    Posts
    67

    Default

    I believe that there was 5W of 808. not sure though...

    If the 808 gets 4.6A that's ok. If 808 works, then most probably the resonator is out of alignment.

  3. #3
    Join Date
    Apr 2009
    Location
    Zürich-Bangkok-Dubai
    Posts
    275

    Default

    CNI Are best friends when it comes to purchase , but when it comes to open up their units, they become transparent.
    My furthest with them about opening the head was they asked me for my serial # of the unit, and never heard from them since ever , also reminded them but seems to be gone!

    Problem was - 808nm diode kaputt, and I used my camcorder to pick up the IR light without me being exposed to it.
    Do be very careful with 808nm , invisible danger!

    Good Luck!
    Philipp Wetter

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •