Originally Posted by
buffo
There are no special connections required. You connect the video projector to your video card using a VGA cable (or a DVI cable, or even an HDMI cable if you want) just as you would normally.
Then, in Beyond you select that video display device and assign it to a projection zone as if it was just another controller with a laser projector attached. Boom! You're done.
All the normal settings (geometric correction, beam attenuation map, etc) still work exactly the same. It's just that the output is sent to the video card that the DLP projector is hooked up to, instead of to the QM2000 or FB3 board.
If you already have a video projector and a licensed copy of Beyond, you can set this up at home right now.
Adam
Hey thanks!,
Ive got to try this ASAP..
pretty much got everything i need to try it out .
RGB laser projectors
Pangolin Beyond .NET
APC40 Midi controllers
Pangolin FB3 controllers
DZ splitter
LS MegaWatt Green Machine